Here’s a fun Christmas project using SVG Cuts and felt. These were so easy to make I didn’t even have to use my sewing machine, just some Heat and Bond and hand stitching Wouldn’t these make a cute Teachers gift!

SVG Collections Used

Merry and Bright SVG Kit Clara’s Christmas Eve SVG Kit Warm Gingerbread Cards SVG Kit Everyday Winter Cards SVG Kit

Supplies Used

• Felt
• Heat and Bond – No Sew Ultra Hold
• Heat and Bond – Sewable Lite
• Thread
• Trendy Twine
• Sequins
• Ribbon
• Buttons
• Enamel Dots
• Fabric Glue
• Pom Poms
• Fiberfill

Dimensions

Cardinal Ornament

Merry and Bright SVG Kit (Cardinal Skating Card)
accent_color.svg	11.635"w x 5.5"h	white
cream.svg	4.135"w x 1.575"h	cream
green.svg	5.170"w x 1.805"h	green
orange.svg	.645"w x .665"h	orange
red.svg	5.430"w x 4.660"h	red
red_light.svg	3.230"w x 1.800"h	red

 Gingerbread Man Ornament

Warm Gingergread Cards SVG Kit (Gingerbread Man Card)
red.svg	4.150"w x 3.175"h	red
white.svg	5.020"w x 5.5"h	white
(Extras)
gingerbread_flat.svg	4.135"w x 5.5"h	brown

 Peppermint Candy Ornament

Clara's Christmas Eve SVG Kit (Peppermint Card)
card_base.svg	6.355"w x 8.655"h	white
red.svg	3.810"w x 3.760"h	red
green.svg	4.430"w x 4.315"h	green

 Snowman Ornament

Everday Winter Cards SVG Kit (Snowman Card)
white.svg	11.570"w x 7.460"h	white
carrot.svg	.525"w x .465"h	orange
hat_mittens.svg	3.365"w x 3.70"h	blue
accents.svg	3.365"w x 2.070"h	blue

Instructions

1. Each base piece I duplicated and mirrored it, so you have a front and back.
2. Follow the heat and bond directions, you’re basically ironing the heat and bond onto the felt, no steam.
3. The top layers I used the no sew heat and bond and for the bottom base pieces the sewable since I was stitching them together.
4. Make sure you have a sticky mat, you want the fabric to stick down good.
5. Peel off the backing and place the heat and bond side down on your mat.
6. I used my Silhouette, blade 10, speed 2 and pressure 33, double cut, it cut very good, some spots I had to pull and use a scissor a little but not bad.
7. I ironed the top layers piece by piece onto the front base piece of each ornament.
8. Do any sewing of embellishments before you sew them closed.
9. Start sewing around and before closed all the way stuff with fiberfill add your ribbon or twine to hang and finish sewing them up.
10. I used fabric glue for some of the embellishments.

Design Tips

• The slower the speed the better the felt cut.
• I used buttons and enamel dots for eyes, instead of cutting out the smaller pieces.
• I think sewing each layer would look very cute too

I really enjoyed making these, it’s so fun to do different things with your cutting machine and SVG Cuts. The possibilities are endless.